lisätty Kassa

Yli 50 €:n tilaukset Custom Boards Premium-jäsenille ilman postikuluja

 

Disaster Area cables - 1/4" TRS to 5-pin MIDI (2 ft, MJ-5P)

Disaster Area

CB1778

Control your 5-pin MIDI devices with MultiJack-enabled Disaster Area devices.
The Disaster Area MJ-5P is used to connect: 
FROM: MultiJack
TO: 5-pin MIDI input of a device

--

MJ-5P directions for use:

DMC Gen3 (ALL)

Open the pedal and flip all three DIP switches to the “ON” / up position.  If using MJ2 or MJ3 on a DMC-6 / DMC-8 Gen3, flip the fourth DIP switch to the “OFF” position.

Replace the lid and power the controller on while holding the lower left and right buttons until SETUP is displayed.

Tap the L or R button until JACK or MJ1 / MJ2 / MJ3 is displayed, then tap the mode or SAVE button.

Tap the L or R button until MIDI is displayed, then tap the mode button again to return to the menu.

Tap the L or R button until J Ch or 1CH / 2CH / 3CH is displayed, then tap the mode button to edit.

Tap the L or R buttons until the desired channels (A, B, C, or any combination) are displayed.  J 000 will send MIDI on all channels but will filter out MIDI clock.

Tap the mode button to return to the menu, then hold the mode button to save.

Connect the TRS to MIDI cable to the MultiJack and your MIDI device.

SMARTClock:

Connect the TRS plug to the MultiJack.

Enter Setup mode on the SMARTClock by holding the encoder knob at power-on.

Navigate to the JACK settings and tap the encoder knob to set.

Set the JACK setting to either MIDI (sends all MIDI messages to the MultiJack) or nCLK (sends all MIDI messages except MIDI Clock to the MultiJack.)

Tap the encoder knob to exit.

Hold the encoder knob to save.

DMC-3XL Gen2 / DMC-4 Gen2:

Connect the TRS plug to the Expression Pedal input.

Enter Setup mode by holding the mode button at power on (center button for DMC-3XL, upper-right for DMC-4.)

Tap the left button until “E” is displayed on the left side of the screen.

Tap the right button until “MID” is displayed on the right side of the screen.

Hold the mode button (center button for DMC-3XL, upper-right for DMC-4.)


Tuoteryhmät: Johdot ja Liittimet, Disaster Area

Kategoria: MIDI-johdot

Toimitukset Suomeen

Lähetys saman päivän aikana

Liity Custom Boards Premiumiin ja saa ilmaiset toimitukset EU:n sisällä sekä ensimmäisenä tiedon koulutuksistamme, tarjouksistamme ja uusista artikkeleistamme.

LIITY CUSTOM BOARDS PREMIUMIIN